07 January, 2012 #Technology

UBoot – Kurobox – Supported Commands

  • RB
Supported Commands

?       – alias for ‘help’
base    – print or set address offset
bdinfo  – print Board Info structure
boot    – boot default, i.e., run ‘bootcmd’
bootd   – boot default, i.e., run ‘bootcmd’
bootm   – boot application image from memory
bootp   – boot image via network using BootP/TFTP protocol
cmp     – memory compare
coninfo – print console devices and information
cp      – memory copy
crc32   – checksum calculation
dhcp    – invoke DHCP client to obtain IP/boot params
diskboot- boot from IDE device
echo    – echo args to console
erase   – erase FLASH memory
ext2load- load binary file from a Ext2 filesystem
ext2ls  – list files in a directory (default /)
flinfo  – print FLASH memory information
go      – start application at address ‘addr’
help    – print online help
ide     – IDE sub-system
loadb   – load binary file over serial line (kermit mode)
loads   – load S-Record file over serial line
loop    – infinite loop on address range
md      – memory display
mm      – memory modify (auto-incrementing)
mtest   – simple RAM test
mw      – memory write (fill)
nfs     – boot image via network using NFS protocol
nm      – memory modify (constant address)
pci     – list and access PCI Configuration Space
ping    – send ICMP ECHO_REQUEST to network host
printenv- print environment variables
protect – enable or disable FLASH write protection
rarpboot- boot image via network using RARP/TFTP protocol
reset   – Perform RESET of the CPU
run     – run commands in an environment variable
saveenv – save environment variables to persistent storage
setenv  – set environment variables
tftpboot- boot image via network using TFTP protocol
version – print monitor version

0 Comments on UBoot – Kurobox – Supported Commands

Leave a Comment

Your email address will not be published. Required fields are marked *

You Might Be Interested In